How to Open Gas Tank on 2014 Ford Explorer
Opening the gas tank on a 2014 Ford Explorer is a relatively straightforward process, but it’s important to follow the correct steps to ensure safety and avoid any damage to the vehicle. Whether you need to fill up with fuel or replace the fuel cap, this guide will walk you through the process step by step.
Step 1: Park on a Flat Surface
Before you begin, make sure your 2014 Ford Explorer is parked on a flat and level surface. This will ensure that the vehicle is stable while you open the gas tank. Engage the parking brake to prevent the car from rolling while you work on it.
Step 2: Locate the Gas Tank Release Lever
The gas tank release lever is typically located on the driver’s side rear fender. Look for a small lever or handle that is usually labeled with the word “Fuel.” In some models, the lever may be covered by a plastic cover. If so, gently pull the cover off to reveal the lever.
Step 3: Pull the Gas Tank Release Lever
Grasp the gas tank release lever with your hand and pull it upwards. You may need to apply some force to release the lever. Once it is released, the lever will lock into place, allowing you to open the gas tank cover.
Step 4: Open the Gas Tank Cover
With the lever released, the gas tank cover should be visible. It is usually held in place by a few clips or a latch. Gently lift the cover up and away from the vehicle. If you encounter any resistance, check for additional clips or latches that may need to be released.
Step 5: Fill Up or Replace the Fuel Cap
Once the gas tank cover is open, you can proceed with filling up the tank or replacing the fuel cap. If you are filling up, make sure to follow the pump instructions and keep the nozzle in the tank until the fuel level reaches your desired amount. If you are replacing the fuel cap, simply place the new cap on the tank and press down until it clicks into place.
Step 6: Close the Gas Tank Cover
After you have finished filling up or replacing the fuel cap, it’s time to close the gas tank cover. Gently press the cover down until it clicks into place. Make sure it is securely closed to prevent any fuel leaks.
Step 7: Return the Gas Tank Release Lever to its Original Position
Finally, return the gas tank release lever to its original position by pushing it down until it locks into place. Replace any plastic covers or clips that were removed during the process.
By following these simple steps, you can easily open the gas tank on your 2014 Ford Explorer. Always remember to exercise caution and consult your vehicle’s owner’s manual for any specific instructions or safety precautions.
