How to Reset Tire Pressure Sensor 2020 Ford Explorer
Maintaining the correct tire pressure in your 2020 Ford Explorer is crucial for safety, fuel efficiency, and overall performance. The tire pressure monitoring system (TPMS) alerts you when the tire pressure is low, but sometimes it may display a warning light even when the tires are properly inflated. Resetting the tire pressure sensor in your 2020 Ford Explorer is a straightforward process that can help clear any false alerts. In this article, we will guide you through the steps to reset the tire pressure sensor in your 2020 Ford Explorer.
Step 1: Park Your Vehicle on a Flat Surface
Before starting the process, ensure that your 2020 Ford Explorer is parked on a flat and level surface. This will help you get accurate tire pressure readings later on.
Step 2: Turn on Your Vehicle
Turn on your 2020 Ford Explorer and wait for the engine to warm up. This step is important because the TPMS needs a warm engine to operate correctly.
Step 3: Set the Tire Pressure to the Recommended Level
Check your vehicle’s owner’s manual to find the recommended tire pressure for your 2020 Ford Explorer. Make sure all four tires are inflated to the correct pressure.
Step 4: Turn off Your Vehicle
After setting the tire pressure to the recommended level, turn off your 2020 Ford Explorer and wait for a few minutes to allow the TPMS to reset.
Step 5: Access the Tire Pressure Sensor Reset Button
Locate the tire pressure sensor reset button in your 2020 Ford Explorer. It is typically located on the driver’s door jamb or on the dashboard. If you cannot find it, consult your vehicle’s owner’s manual for the exact location.
Step 6: Press and Hold the Reset Button
Press and hold the tire pressure sensor reset button for about 10 seconds. During this time, the TPMS will reset and clear any false alerts.
Step 7: Verify the Reset
Once you have pressed and held the reset button for 10 seconds, release it. Turn on your 2020 Ford Explorer and check the dashboard to ensure that the tire pressure warning light is off.
Conclusion
Resetting the tire pressure sensor in your 2020 Ford Explorer is a simple process that can help you avoid unnecessary alerts and ensure your vehicle’s safety and performance. By following these steps, you can easily reset the TPMS and maintain the correct tire pressure in your vehicle. Remember to regularly check your tire pressure and keep it at the recommended level for optimal performance.
