How to Connect Bose Acoustimass 15 to Receiver
Integrating the Bose Acoustimass 15 into your home theater system can significantly enhance your audio experience. The Acoustimass module, designed to amplify and enrich the sound from your speakers, can transform your room into a cinematic wonderland. In this article, we will guide you through the process of connecting the Bose Acoustimass 15 to your receiver, ensuring that you can enjoy the full potential of your home theater setup.
Step 1: Preparation
Before you begin the connection process, gather the following items:
– Bose Acoustimass 15 module
– Your home theater receiver
– Speaker wire
– A Phillips-head screwdriver (if required)
Ensure that both your receiver and the Acoustimass 15 are turned off before you start.
Step 2: Connecting the Subwoofer
1. Locate the subwoofer output on your receiver. This is usually a mono output, marked as LFE (Low Frequency Effects) or simply Sub Out.
2. Take one end of the speaker wire and strip about 1/2 inch of insulation from it.
3. Connect the stripped end of the speaker wire to the subwoofer output on the receiver, ensuring a secure connection. The wire may have a positive and negative marking to indicate the correct orientation.
4. Connect the other end of the speaker wire to the Acoustimass 15 module, again ensuring a tight and secure connection.
Step 3: Connecting the Speaker Cables
1. Locate the speaker input on the Acoustimass 15 module. This is where you will connect the speaker wires from your main speakers.
2. Connect the speaker wire from your main speakers to the corresponding input on the Acoustimass 15 module. The inputs are typically labeled with the speaker channels they correspond to (e.g., Left, Right, Center).
3. Ensure that the speaker wires are securely connected to the inputs.
Step 4: Powering Up
1. Turn on your receiver and the Bose Acoustimass 15 module.
2. Set the volume level on the receiver to a comfortable starting point.
3. Use the receiver’s remote control to navigate to the Acoustimass 15’s input. This may require you to set the input selector on the receiver to the correct source.
4. Adjust the volume and balance settings on the receiver to fine-tune the sound.
Step 5: Calibration
For optimal performance, you may need to calibrate the Acoustimass 15 using the Bose room equalizer. This process may vary depending on your receiver model and the specific features of the Acoustimass 15. Consult the user manual for detailed instructions.
By following these steps, you should now have successfully connected your Bose Acoustimass 15 to your receiver. Enjoy the rich, immersive sound that this powerful subwoofer brings to your home theater experience.
